Yokogawa 414 Batch Controller Manual de usuario Pagina 49
- Pagina / 51
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
8.1 ERROR CODES
The instrument has extensive self test facilities and will display an error code if
it detects an invalid condition. If the instrument displays an error code other
than those listed below, please contact the factory.
Error codes are displayed as "Err 12" and a list of commonly encountered codes
are given below:
Error Codes
Input Errors
11 Invalid input configuration programmed.
13 Signal less than 3.5mA.
14 Communications Input error (RS232/422/485 Interface).
Output Errors
21 Invalid output configuration.
22 Communications error - Baud rate not set.
23 Communications error - Printer fault.
Calibration Errors
30 Zero Value not Allowed.
33 Invalid Printer Type.
34 Invalid Volume Units selected.
Trouble Shooting 47
- BATCH CONTROLLERS 1
- MODEL 414A 1
- 1
- CONTENTS 3
- 1. INTRODUCTION 5
- 1.1 MODEL NUMBER DESIGNATION 6
- 2. SPECIFICATION 7
- 3. OPERATION 9
- 3.1 FRONT PANEL OPERATION 10
- 3.2 BATCH OPERATIONS 13
- Filtered Response 22
- Unfiltered Response 22
- 3.4 TOTAL CONVERSION 24
- 24 Operation 26
- 4. OPTIONS 27
- Figure 2 RS485 Interface 29
- Options 27 29
- 5. CALIBRATION 32
- 5.3 PROGRAMMING OPTIONS 38
- 6. INPUT CIRCUITS 41
- INPUT CONNECTIONS 42
- 40 Input Circuits 42
- 6.3 REMOTE SWITCH INPUTS 43
- 7. INSTALLATION 44
- 8. TROUBLE SHOOTING 47
- 8.1 ERROR CODES 49
Behringer Hudební nástroje uživatelské příručky
Začínající na K
Comentarios a estos manuales