Yokogawa PC-Based MX100 Manual de usuario descargar pdf (Pagina 29)

IM MX100-02E

Click Disconnect.

Reconnecting to the Same MX100

• If the Connection screen is opened, click Connect.

Click Connect.

IP address of the MX100 connected previously

• If the Integration Monitor is closed, start the Integration Monitor.

The connection is made automatically when you start the Integration Monitor.

When Connection Cannot Be Made or When Connecting to Another MX100

If the MX100 that you are connecting to is already connected by another user or the

connection cannot be made such as due to an incorrect designation of the IP address

and you try to make a connection, the dialog box shown below remains on the screen.

If this happens, click Cancel in the dialog box, and click Search on the Connection

screen. If the MX100 is in the same network segment as the PC, an icon indicating the

MX100 appears in the frame containing the Search button. If the icon appears, click the

icon to check the network information (see page 27). The user connected to the MX100

is indicated by User; the software program connected to the MX100 is indicated by

Software.

Click Search.

Note

If the module configuration changes before connecting an MX100 that has been connected

previously, a message, “Some detected modules do not match the current software

configuration. Rebuild based on the current MX hardware setup?” appears. For procedures in

this situation, see “Reconfiguring the System” in section 2.2 of the MX100 Standard Software

User’s Manual (IM MX180-01E).

Operations of the MX100 Standard Software

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 52 53

Sin comentarios

Yokogawa PC-Based MX100 Manual de usuario Pagina 29