Yokogawa SPS24 Manual de usuario descargar pdf (Pagina 9)

<1. Introduction>

1-3

IM 12A01S02-01E 1st Edition : May 10, 2013-00

1.2.1 Connection Information Field

Theconnectioninformationelddisplaysthestatusandinformationofconnectedsensors,and

can also be used for switching target sensors.

Sensorscanbeconnectedordisconnectedbyclickingonthe[Connect]or[Disconnect]buttons

atthebottomoftheeld.

Toggle between wide/narrow display

Connected sensor button

Sensor not connected

Target sensor

for calibration

Target sensor

for display

Model (SensorType)

Sensor number

ID(Serial No.)

Comments

Figure1.3 Screenexampleofconnectioninformationeld

When “Sensor Not Connected” is shown despite a sensor being connected, disconnect the

sensor from the cable, reconnect, and click [Connect] again.

Information about the connected sensor is displayed on the sensor connection button along with

the connection status.

The sensor type can be set using [Sensor setup] (pH, ORP, pH+ORP).

Anoptionalcommentcanbeenteredforsensoridenticationusing[Databaseviewer]–[Edit

data].

When the display shows the following icons, see “5. Error Information”.

1.2.2 Toolbar

Thetoolbarhasfunctionswitchbuttonsfor[Sensormanagement],[Databaseviewer],[Error

information], [Setup], and others. Clicking a button displays the corresponding function screen.

Fordetails,seesections3to7.

This operation is also available from [View] on the menu bar.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Sin comentarios

Yokogawa SPS24 Manual de usuario Pagina 9