Yokogawa Data Acquisition with PID Control CX2000 Manual de usuario descargar pdf (Pagina 56)

3-40

M-4659

WhenobtainingtheIP address from DHCP

• DHCP

Set [DHCP] to [ON].

• DNS accession

To automatically obtain the DNS server address, select [ON]. Otherwise, select [OFF].

If you select [OFF], you must set the IP address of the DNS server.

• Host-Name Register

To automatically register the host name, select [ON].

• Host Name

Set the DX1000/DX2000’s host name using up to 64 alphanumeric characters.

• Domain Name

Set the network domain name that the DX belongs to using up to 64 characters.

• Server Primary, Server Secondary (not necessary when DNS accession

is enabled)

• Domain Primary, Domain Secondary

Set up to two domain sufxes: primary and secondary.

Keep Alive

To disconnect when there is no response to the test packets that are periodically sent,

select [ON]. Otherwise, select [OFF].

Time out

To use the application timeout function, select [ON]. Otherwise, select [OFF]. If you

select [ON], a [Timeout time] is displayed.

• Timeouttime(min.)

Set the timeout value between 1 and 120 (minutes).

Checking the communication status

The Ethernet communication status can be confirmed with the LED lamp that is provided

on the Ethernet connector on the DX1000/DX2000 rear panel or the [Ethernet link] that is

shown at the upper right of the basic setting screen.

3.6 Entering Basic Settings

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 285 286

Sin comentarios

Yokogawa Data Acquisition with PID Control CX2000 Manual de usuario Pagina 56