Yokogawa EJX210B Manual de usuario descargar pdf (Pagina 21)

100

101

<4. Installation>

4-3

IM 01C27C01-01EN

4.6 Mounting the Flushing

Connection Ring

4.6.1 Mounting to Pressure Detector

Section

The ushing connection ring is mounted to high

pressure side pressure detector section as shown

in Figure 4.5.

At the factory shipment, the ushing connection ring

is already assembled and attached to high pressure

side process detector section.

F0405.ai

Pressure-detector section

Drain/vent plug

Ring

Ring holder

Spiral gasket

View from pressure detector section side

Groove for installing

spiral gasket

Figure 4.5 Mounting to Pressure Detector Section

(1) Mount the ring holder on the ring and loosely

tighten the mounting screws.

(2) Place the spiral gasket in the ring groove. With

the ring correctly aligned and ush with the face

of the pressure detector, securely tighten each

ring holder’s mounting screws.

(3) Position the ring so that the drain/vent plugs are

aligned straight up and down.

4.6.2 Mounting to Process Flange

Tighten the bolts to completely close the gap

between the ring and the pressure detector section.

The mating ange, gasket, stud bolts and nuts are

to be procured by the customer.

F0406.ai

Ring

Diaphragm

Pressure-detector

section

Gasket

Mating flange

Spiral gasket

Figure 4.6 Mounting to Process Flange

IMPORTANT

• Conrm that there is no gap between the ring

and the process-detector section after they

are mounted on the process ange. A gap

can lead to a sudden, explosive release of

process uids.

• When mounting or removing the ring,

take care not to tilt the pressure detector

downward as the ring can slip off and cause

injury.

• When re-mounting the ring, use the new

spiral gasket as shown in below table.

Table 4.1 Spiral Gasket for Pressure Detector

Section Side*

Part number Size Description

F9350SV ø100×ø120×t4.5 For 3-inch ange

F9970XF ø100×ø120×t4.5 For 3-inch ange**

F9350ST ø70×ø90×t4.5 For 2-inch ange

F9970XD ø70×ø90×t4.5 For 2-inch ange**

F9346ZH ø60×ø75×t4.5 For 1 1/2-inch ange

F9970XB ø60×ø75×t4.5 For 1 1/2-inch ange**

*: Material; 316SST (Hoop), PTFE Teon (Filler)

**: For oil-prohibited use (Option code: /K1, /K5)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 100 101

Comentarios a estos manuales

Sin comentarios

Yokogawa EJX210B Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Yokogawa EJX210B